Valid for firmware revision 1.00 and above
CIM-130&136-KLRV MAN - EN – p.
15 of 16
unit.
When the SMS TO ALL PHONES INCLUDED, Commands sent via SMS text message are accepted only from phone
numbers programmed in the control unit (tel 1-2-3). If the function is disabled, ONLY PHONE NUMBERS registered in the
control unit can perform SMS commands.
PROGRAMMING THE CELL PHONE NUMBERS OF THE USERS WHO ARE TO BE NOTIFIED WHEN THE MOTOR PUMP IS IN
ALARM CONDITION
•
PROGRAM
see USER PROGRAMMING.
IMPORTANT NOTE
In order for a command sent via SMS to be interpreted correctly, it is important to programme the telephone number
exactly as it is given by the mobile telephone network, and therefore inclusive of international dialing code and without
the first zero of the dialling code (if there is one) of the telephone company.
Ex1:
Italian number = 348123456
programme + 39348123456
Ex2:
English number = 0797123456 (leave out the 1st zero)
programme + 44797123456
In any case, refer to the national numbering system.
TO CONFIRM RECEPTION OF THE
SMS WARNING MESSAGE
AND
STOP THE SENDING OF SUBSEQUENT
MESSAGES, SEND
A MESSAGE FROM YOUR CELL PHONE USING THE PHRASE
OK.
After confirmation
the display will show
HOW TO VIEW THE STATUS OF THE MOTOR PUMP
To request an
update on the
status of the
motor pump,
enter the
code
001
into
your cell phone
and send it by
SMS to the unit.
On your cell phone,
it is possible to view:
- hour-meter
- oil pressure gauge
- water or oil thermometer
- tachometer
- pump water pressure gauge
- fuel level
- battery voltmeter
- timer
(displays the working time remaining before the motor pump is set to stop)
TELEPH.GSM
NOTIFIED