7
INTRODUCTION
Read this instruction manual carefully to know the specifications of the dispenser. As all
mechanical products, this unit requires cleaning and maintenance. It’s working order can
be compromised by possible errors made by the operator during disassembly and
cleaning. For this reason it is important that the staff in charge of the dispenser is qualified
to carry out the day to day operations, which are dismantling, cleaning, sterilisation and
reassembly.
INSTALLATION
Remove the dispenser from the packaging. (This should be kept for any future equipment)
Check the dispenser has not been damaged during transport.
The forwarding agent
must be notified immediately of any claim.
Install the dispenser on a counter top that will support its weight, even with a full load.
Before connecting the dispenser electrically check that the voltage (in the network) is as
shown on the data plate. Plug the unit into a grounded, protected single phase electrical
supply according to the applicable electrical codes and the specifications of your machine.
Ensure that the unit is grounded correctly; if not it may cause electric shock to persons or
damage the dispenser.
The dispenser does not leave the factory cleaned and sanitized. Prior to use it must be
disassembled, cleaned and sanitized according to the instructions in chapter CLEANING.
TO OPERATE SAFELY
Read the instruction booklet before using the dispenser.
Use the dispenser only if it is grounded correctly.
Do not use extension cords to connect the dispenser electrically.
Do not operate the dispenser if it is not closed and blocked with screws.
Do not open the dispenser for cleaning or maintenance without ensuring it has been
disconnected from the electricity.
Do not remove the container when the unit is in operation.
Do not remove the container from the dispenser when it contains products.
OPERATING PROCEDURES
Clean and sanitized the dispenser prior to use following the instructions in chapter
CLEANING.
Fill the bowl with the product, prepared according to the instructions of the
manufacturer.
Install the cover above the container making sure that it is placed correctly.
Set the control switch (see charter COMMAND DESCRIPTIONS)
The dispenser should always operate with the cover installed in order to prevent possible
contamination of the product.
The dispenser must run uninterruptedly; cooling will stop automatically when the
product is ready for dispensing. The mixing device will continue to operate.
