ENG man BRAVO-FUNK-915 00
BRAVO-FUNK-915 Radio remote control system
- Page 17 -
ENGLISH
7. TROUBLESHOOTING
7.1 TYPE OF TROUBLE
Battery Check
LED SIGNAL
POSSIBLE CAUSE
SUGGESTED REMEDY
LED does not switch on
BATTERY ABSENT
Check that the battery is present and the battery
contacts are clean.
Green LED flashes rapidly
SELF-DIAGNOSIS OK
Press START until the green LED flashed slowly. If this
does not occur, see Par.7.3
Red LED on for 1 second, and
then the transmitter switches off
STOP MUSHROOM
BUTTON PRESSED
Release the STOP mushroom button.
Red LED on for 2 second, and
then the transmitter switches off
IDENTIFICATION CODE
NOT ACQUIRED
Perform the acquisition procedure of the access code
(Par. 4.1).
TX UNIT FAILURE
Contact the ELCA assistance service.
Red LED flashes 2 times
and
then the transmitter switches off
ON-OFF COMMAND
ACTIVE
Check that there are no ON/OFF commands active on
the transmitter when switched on.
Red LED flashes 3 times
and
then the transmitter switches off
LOW BATTERY
Recharge the batteries (see Chap. 6).
Replace the battery with a charged one.
Red LED flashes 4 times
and
then the transmitter switches off JOYSTICK OUT OF ZERO
Check that there are no joysticks out of zero when
power on is performed.
For any other signals not listed
above
See Paragraph 7.2.
SIGNAL
POSSIBLE CAUSE
SUGGESTED REMEDY
Blue STATUS LED on the
receiver flashes quickly
discontinuously.
RADIO INTERFERENCE
Ensure there are no other similar systems or sources of
noise such as radio bridges or transmitters. Switch the
transmitter off and back on again.
/
EXTERNAL ANTENNA
(if fitted)
Check for correct position and connection.
SYSTEM
INCORRECTLY
INSTALLED
Check system for proper installation (receiving unit
position, metal obstacles,...).
See Paragraph 2.5.
For any causes other
than those listed above
See Paragraph 7.2.
SYMPTOM
POSSIBLE CAUSE
SUGGESTED REMEDY
ONE OR MORE CONTROLS
FAIL TO ACTUATE THE
CORRESPONDING
MOVEMENT.
WRONG WIRING
CONNECTION
Check wiring in the receiving unit (see Paragraph 5.2).
COMMAND
TRANSMISSION FAILED
Contact the ELCA assistance service.
-
RADIO CONNECTION FAILURE
: After having turned the key on the transmitter to position 1, the radio link does not
activate when pressing Start.
The radio connection is active and working when the green Battery Check LED flashes slowly (1 flash every second).
During regular operation, the red LED flashes instead of the green indicating that the battery is low and there are still 10
minutes of battery life.
In the event of no radio link, perform the SELF-DIAGNOSIS OF THE TRANSMITTER: turn the key switch from position
0 to position 1 without pressing Start, the system performs a self-diagnosis, the outcome of which is given by the signal
of the Battery Check LED as shown in the table below:
Note: The lighting of the red LED is accompanied by an acoustic signal.
-
REPEATED RADIO CONNECTION FAILURES
:
-
OPERATING ERROR
:
