ENG man BRAVO-FUNK-915 00
BRAVO-FUNK-915 Radio remote control system
- Page 15 -
ENGLISH
Inversion of the axle of the Joysticks.
-
With the SETUP function enabled, check that all the proportional functions are in rest position. For the potentiometers,
the rest position is with the potentiometer rotated counter-clockwise. Proportional functions out of zero prevent
proper operation of the SETUP function. The presence of two or more proportional functions simultaneously out of
zero is indicated by the rapid flashing of the SETUP LED.
-
On the Transmitter, activate and release the selector with P+/P- indicated from the P+ side and immediately after
activate and release the Start command
-
Repeat the operation described above until the SETUP LED starts blinking 4 times.
-
Move the Joystick or the potentiometer of the function you want to adjust just slightly out of zero and hold it in position.
-
By operating the selector with P+ / P- indicated from the P+ side just once, the axle is inverted.
-
Press the STOP pushbutton to save the changed value. Switch off the receiver to cancel any changes. To perform
other adjustments, bring the Stop in rest position, press Start and resume operations from the two points described
above we have just discussed.
-
To exit the adjustment mode of the Offset voltage, it is necessary to exit the SETUP mode, switching the receiver off
or moving the Elca Logo of the cable protection hood for approximately 10 seconds near to the area on the receiver
indicated with Enable SETUP.
Reset to default Factory settings.
-
With the SETUP function enabled, check that all the proportional functions are in rest position. For the potentiometers,
the rest position is with the potentiometer rotated counter-clockwise. Proportional functions out of zero prevent
proper operation of the SETUP function. The presence of two or more proportional functions simultaneously out of
zero is indicated by the rapid flashing of the SETUP LED.
-
On the receiver, move the Elca Logo of the cable protection hood near the area indicated with Enable SETUP for
3 times. When you have moved it the third time, hold it in position until the yellow SETUP LED starts blinking and,
finally, returns to permanently lit.
WARNING: if you move the Elca Logo away from the area indicated with Enable SETUP before the yellow SETUP LRF
returns to permanently lit, the reset of the default factory settings will be aborted and the reset will not be completed.
Exit from SETUP mode.
-
With the SETUP enabled, remove power supply from the receiver or move the Elca Logo near the area of the
receiver indicated with Enable SETUP, until the SETUP LED goes off (approximately 10 seconds).
