Elbur PB 636 IV, Инструкция по эксплуатации

Страница: 24 / 36

PB 636 IV
Elbur sp. z o.o. sp.k. 24 of 36
7.2. Side rails operating
Note
It is necessary to hold side rails during lowering them to avoid rapid
decrease.
The ends of side rails shall be always at the same level of mattress
support platform head section and foot section.
Warnings
Lowering height of mattress support platform with side rails in the lowest
position or bringing side rails down if mattress support platform is in the
lowest position, can cause foot entrapment!
To raise wooden side rails pull them on an one end
after the other until they lock in its highest position –
there should not be any possibility to move them up
or down.
To lower wooden side rails raise them slightly, push
the locking button and lower them slowly – do not let
to rapid decrease.
7.3. Setting the springiness of mattress support
platform
Warning
Rashness can caused finger entrapment between mattress support
platform and sliding cube.
The springiness for the individual wooden slats can be adjusted using six
slides fixed to the center of the slatted frame, which allows to adjust it
to suit the patient’s weight within certain limits.
 pull slide out (+) to outside bed direction - increase hardness,
 push slide in (-) to inside bed direction – decrease hardness.
7.4. Castors operating
Uwaga
There should be access to castors at all the time.
They have to be placed along the bed before locking them,
In standard version of PB 636 IV for the purpose of
activating the brake push the foot lever down as far as
it goes. For the purpose of deactivating the brake push
the foot lever toward the corner pole as far as it goes.