Elbur B 521 II, Инструкция

Страница: 16 / 36

ELBUR: PB 521 II, PB 526 II
Elbur sp. z o.o. sp.k. 16 of 36
4.3. Control box
Control box is placed on back rest drive unit. In case
of failure of any component, there are installed special
systems blocking adjustment functions. Control box is
protected against ingress of moisture and overload
protection system:
•
limit switches turn off drives, when they get to
the limit position,
• thermal switch turns off control box if it overheats. It should be ready
to re-use after 30 minutes break.
The EPR mains cable is fitted with a push-on anti-kink device and tension
protection.
4.4. Hand switch
The electrical adjustment can be made using the hand
switch. Functions can be controlled by the press of the
button on keypad on the front side. The fixing bracket
on the rear of the hand switch can be used to hold it in
an easily reachable position on the nursing bed.
Operating of hand switch is described in subclause 7.1.
5.0. Accessories and spare parts
Warnings
Use only original Elbur accessories and spare parts – modification of
nursing beds is strictly forbidden without authorization of our company.
It is necessary to perform specific control tests after modifying the
nursing bed to make sure that it is going to work properly.
Accessories and spare parts can be ordered from distributor or Elbur
company. For reasons of safety, it is allowed to use only original spare parts
or accessories from Elbur sp. z o.o. sp.k. Otherwise, our company will
assume no liability for any accidents, damage, injury and risks that come
about through the use of other spare parts or accessories.
6.0. Assembly
Before commencing assembly of the nursing bed, please read carefully
instruction manual and verify the shipment contents with your order. Please
contact your distributor or Elbur customer service, if you miss any items
or get something in bad condition.
Warnings
Two people qualified in nursing bed’s operating are required to assembly.
In order to avoid wrong assembly, read carefully instruction manual
and labelling on the bed. Remember also to use proper tools.