25
24
Mute Mode
Press the Home Mode button " " and
then the Arm " " or Disarm " " button
immediately after. Doing so, the control
panel does not beep when you arm or disarm
your system.
Emergency Mode
Regardless the status of the system, the
alarm is triggered when the SOS button "
SOS
"
is pressed on the remote control.
At the same time, the control panel sends a
notification by SMS ("
RC-01 SOS
", 01 being
the remote control's number) and dials the
pre-stored phone numbers.
Register in the control panel
Refer to the instructions in the table on page 8 of this manual "
Remote & Keypad
".
Specifications
Power supply
DC 3V (CR2025 button battery x1)
Static current
≤10 uA
Operating current
≤7 mA
Transmission distance
≤ 80 m (in open area)
Radio-frequency:
433MHz (±75KHz)
Housing material
ABS plastic
Operating conditions
Temperature: -10°C ~ +55°C
Relative Humidity: ≤80%
(non-condensing)
Dimensions
57 x 31 x 11 mm
Wireless Motion Detector
Design
3
1
2
1. LED indicator
2. Detection window
3. Bracket
LED indications
Blinks continuously: self-testing
Blinks once: an intruder is detected
Blinks twice: self-testing is complete;
entering working mode.
Blinks once every 3 seconds: under-
voltage indication, the batteries must be
replaced. (You will be informed by SMS
when the batteries are low if the motion
detector is registered in the control panel.)
PCB Layout
Alarm zone
setup
Tamper
switch*
Infrared
sensor**
AA 1.5V LR6
Antenna
LED working
indicator
*
Tamper switch
When the alarm system is armed, the tamper switch will trigger the alarm if the case is opened.
**Infrared sensor
Detects the infrared rays released by human body motion. Do not touch the surface. Keep the surface
clean.
