17
GAS TAPS
Periodic lubrication of the gas taps must be
carried out by specialist personnel only.
In the event of operating faults in the gas
taps, call the Service Department.
INSIDE OF OVEN
The oven should always be cleaned after
use when it has cooled down.
The cavity should be cleaned using a mild
detergent solution and warm water. Suita-
ble proprietary chemical cleaners may be
used after first consulting with the manu
-
facturers recommendations and testing a
small sample of the oven cavity. Abrasive
cleaning agents or scouring pads/cloths
should not be used on the cavity surface.
NOTE:
The manufacturers of this applian-
ce will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay special
attention no to touch the hot heating
elements inside the oven cavity.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains.
When the cooker is cool unscrew and re-
place the bulb with another one resistant to
high temperatures (300°C), voltage 230V,
type E14 and same power (check watt po-
wer as stamped in the bulb itself) of the re-
placed bulb.
Note: Oven bulb replacement is not cove-
red by your guarantee.
BURNERS
They can be removed and washed with
soapy water only.
They will remain always perfect if cleaned
with products used for silverware.
After cleaning or wash, check that burner-
caps and burner-heads are dry before pla-
cing them in the respective housings.
Check that the electrode “
S
” (figs. 6.1, 6.3)
next to each burner is always clean to en-
sure trouble-free sparking.
Check that the probe “
T
” (figs. 6.1, 6.
3)
next to each burner is always clean to en-
sure correct operation of the safety valves.
Both the probe and ignition plug must
be very carefully cleaned.
Note: The electrode “S” must be very
carefully cleaned. To avoid damage to
the electric ignition do not use it when
the burners are not in place.
CORRECT REPLACEMENT OF
THE AUXILIARY, SEMIRAPID AND
SEMI-RAPID BURNERS
It is very important to check that the bur-
ner flame distributor
F
and the cap
C
has
been correctly positioned (see figs. 6.1
- 6.2) - failure to do so can cause serious
problems.
CORRECT REPLACEMENT OF THE
TRIPLE RING BURNER
The triple ring burner must be correctly po-
sitioned (see fig. 6.5); the burner rib must
be enter in their logement as shown by the
arrow (see fig. 6.3).
The burner correctly positioned must not
rotate (fig. 6.4).
Then position the cap
A
and the ring
B
(figs. 6.4 - 6.5).
Содержание ELSC 90 DF
Страница 2: ...2 ...
Страница 18: ...18 S F C T Fig 6 1 Fig 6 2 A B S T Fig 6 3 Fig 6 4 Fig 6 5 ...
