27
INSIDE OF OVEN
The oven should always be cleaned after
use when it has cooled down.
The cavity should be cleaned using a mild
detergent solution and warm water.
Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations and
testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/
cloths should not be used on the cavity
surface.
NOTE:
The manufacturers of this appliance
will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay special
attention no to touch the hot heating
elements inside the oven cavity.
OVEN FITTING OUT
1.
MODELS WITH EMBOSSED CAVITY
The oven shelf is provided with a
security block to prevent accidental
extraction. It must be inserted
operating as per figure 2.1. To remove
it, operate in the reverse order.
2.
MODELS WITH SIDE WIRE RACKS
•
Assemble the wire racks to the oven
walls using the 2 screws (fig. 2.2).
In the models with catalytic panels
interpose the catalytic panels “
A
” with
the arrow up (fig. 2.2).
Models with side lamp:
The catalytic
panel with the hole for the side oven
lamp must be positioned on the left
oven wall. DO NOT INTERPOSE THE
CATALYTIC PANEL WITHOUT THE
HOLE ON THE LEFT OVEN WALL.
•
Slide in, on the guides, the shelf and
the tray (fig. 2.3).
The shelf must be fitted so that the
safety notch, which stops it sliding out,
faces the inside of the oven; the guard
rail shall be at the back.
•
To dismantle, operate in reverse order.
A
A
HOLE FOR SIDE LIGHT
(SOME MODELS ONLY)
Fig. 2.3
Fig. 2.2
Guard rail
Stop notch
Fig. 2.1