User Manual
Doc.Ref : EVO-KNX-UM
EVO-KNX
– Paradox KNX Interface
Revision :
2.01
Page :
9 of 23
© ELAUSYS SPRL
This document cannot be reproduced fully or partially without written authorization
3. PARAMETERS
The KNX interface parameters are defined in the “parameters” tab of the device, in the ETS project.
3.1
GENERAL SETTINGS
The following parameters are defined in the General section of the device parameters:
PARAMETER
VALUES
DESCRIPTION
Use PG Control
▪
Not used (default)
▪
Used
This parameter must
be set to “Not
used” for the paradox EVO interface.
PG Control is not available on this
device.
Use PG Status
▪
Not used (default)
▪
Used
When this parameter is set to “Used”,
the PG status group objects are made
available.
Number of PG
▪
16 (default)
▪
32
Number of PG control and status group
objects to be used
Use Zone Status
▪
Not used
▪
Used (default)
When this parameter is set to “Used”,
the zone status group objects are
made available.
Number of zones
▪
16 (default)
▪
32
▪
48
▪
64
▪
72
▪
96
Number of zone status group objects
to be used.
Zones offset
▪
0 (default)
▪
96
An offset of 0 will use zones 1 to 96
from the alarm system whereas an
offset of 96 will use zones 97 to 192
