Elation VOLT Q5E SIX PACK, Руководство пользователя

Страница: 26 / 34

w w w . e l a t i o n l i g h t i n g . c o m
26
VOLT Q5E™ User Manual ver 2
I N T E R N A L W I R E L E S S D M X R E C I E V E R ( E W D M X )
The VOLT Q5E™ is equipped with an internal Elation Wireless DMX Receiver, which is
fully compatible with an Elation Wireless DMX System.
WORKING WITH THE INTERNAL WIRELESS DMX (EWDMX) System
Access the “ WDMX” sub menu from the “PERSNAL” menu. The “WDMX” sub menu
allows you to “ActWDMX” (turn ON) the system, “ AcDaOut” (turn ON) the system
and send (DMX data OUT) to the wired output port, “WDMXOff” (turn OFF) the
system, or “ClrWDMX” (CLEAR) the EWDMX system.
When the EWDMX system is in the “ActWDMX” mode, the internal DMX “IN” XLR jacks
are turned OFF. However the internal DMX “OUT” XLR jacks will function normally. If
the fixture is powered ON with the internal EWDMX system “ActWDMX” , it will
automatically scan for a wireless DMX signal from an Elation Wireless DMX
Transmitter . If NO wireless signal is received, it will switch to the wired DMX mode.
W A R N I N G !
NEVER connect a fixture to a controller via a DMX cable when the EWDMX
system is in use. This could cause serious damage to the controller!!
SETTING UP THE EWDMX SYSTEM
Follow the instructions included with the Elation EWDMX Transmitter and connect it
to the output of your DMX controller.
To sync your fixture with the Elation EWDMX Transmitter follow the steps below
•
Initially, the EWDMX indicator on the fixture should be solid RED .
•
Press and hold the configuration button on your EWDMX Transmitter for about 3
seconds. The RED / GREEN LED indicators on the EWDMX Transmitter and the fixture
should then begin to flash rapidly for 5~ 10 seconds while the two systems pair.
•
Once the fixture is paired with the EWDMX Transmitter (T1) , the EWDMX status
indicators on the both the fixture and the EWDMX Transmitter will stop flashing
and glow solid GREEN . If paring is unsuccessful repeat the process until paring is secured.
•
The fixture will store the pairing information inside a nondestructive memory bank
once a link is created between the fixture and an
EWDMX Transmitter . The fixture
will remember the paired EWDMX Transmitter even if the fixture is turned OFF for
extended periods of time.