Elation VOLT Q5E SIX PACK, Руководство пользователя

Страница: 16 / 34

w w w . e l a t i o n l i g h t i n g . c o m
16
VOLT Q5E™ User Manual ver 2
DMX-512 CONTROLLER CONNECTION
Connect the provided XLR cable to the female XLR output of your controller and the
other side to the male 3pin input of the
VOLT Q5E™. The diagram below illustrates a
typical DMX-512 connection when the fixture is in the 9 Channel Extended Mode .
You can chain multiple panels together through serial linking. The data link cable
included must be used. Always be sure daisy chain your in and out data
connections, never split or “Y” your DMX connections.
Address 1 Address 10 Address 19
DMX-512 CONNECTION WITH DMX TERMINATOR
A DMX terminator should be used in all DMX lines especially in longer runs. The use of
a terminator may avoid erratic behavior in your DMX line. A terminator is a 120 ohm
1/4 watt resistor that is connected between pins 2 and 3 of a male XLR connector
(DATA + and DATA -). This fixture is inserted in the female XLR connector of the last
fixture in your daisy chain to terminate the line. Using a line terminator will decrease
the possibilities of erratic behavior
.