Elation SMARTY MAX, Руководство пользователя

Страница: 41 / 46

41
E R R O R C O D E S
When power is applied, the unit will automatically enter a “Reset/Test” mode. This mode brings
all the internal motors to a home position. If there is an internal problem with one or more of the
motors an error code will flash in the display in the form of
“XXer”
were as XX will represent a
function number. For example, when the display shows
“0Er”
it means there is some type of
error with the Pan motor. If there are multiple errors during the start-up process they will all flash
in the display. For example: if the fixtures has errors on
Channel 1 , 2 , and 5 all at the same time,
you will see the error message “01Er”, “02Er” , and ”05Er” flash repeated 5 times.
If an error does occur during the initial start-up procedure the fixture will self-generate a
second reset signal and try to realign all the motors and correct the errors. If the error persists
after a second attempt a third attempt will be made. If after a third attempt all the errors have
not been corrected the fixture will make the following determinations:
3 or More Errors -
The fixture cannot function properly with three or more errors therefore
the fixture will place itself in a stand-by mode until subsequent repairs can be made.
Less Than 3 Errors - The fixture has less than 3 errors; therefore, most other functions will work
properly. The fixture will attempt to operate normally until the errors can be correct by a
technician. The errors in question will remain flashing in the display as a reminder of internal errors.
Error Codes subject to change without notice.
ERROR CODES DESCRIPTION
PAN Er
Movement is not located in the default position after the reset.
This message will appear after a fixture reset if the magnetic-indexing circuit
malfunctions (sensor failed, or magnet is missing) or there is a motor failure (defective
motor or a defective motor IC drive on the main PCB). This error may also be displayed
if the head/yoke was blocked during a reset function.
TILT Er
Zoom Er
Movement is not located in the default position after the reset. This
message will appear after a fixture reset if the magnetic-indexing circuit
malfunctions (sensor failed, or magnet is missing) or there is a motor
failure (defective motor or a defective motor IC drive on the main PCB).
Focus Er
Color Wheel Er
Cyan Color Er
Magenta Color Er
Yellow Color Er
CTO Color Er
Rot Gobo Er
Gobo Rot Er
Fix Gobo Er
Animation Er
AnimationRot Er
Prism Er
Prism Rot Er
Prism 2 Er
Prism Rot 2 Er
Frost 1 Er
Frost 2 Er
Iris Er
Flow Er