ELAC OW-V41L / OW-V41S ON-WALL Speakers | www.elac.com | Page 4
Amplifier Terminals
Speakers Connection
After choosing the orientation of the speakers, do the following to avoid damaging the speakers:
• Ensure your equipment is turned off before connecting speakers.
• Use appropriate gauge wires (minimum of 16 gauge wire for runs up to 25 feet).
• Make sure wire polarity is connected correctly. Most speaker cables are coded for ease of use. Make
sure positive (red) connection on the amplifier terminal is connected to the positive (red) on your
speakers. Follow the same instructions for the negative side. Strip off approximately 1/2”of the insulation
from the ends of the speaker cable, twist the bare strands and insert into the binding post.
• Check to ensure positive and negative wires are not touching each other once they’re connected to the
speaker terminals. See Fig.2.
Fig.2
Amplifier Terminals
OW-V41L
OW-V41S
IMPORTANT !
Ensure the switch at the back of the speakers (OW-V41L model only) is in the correct position depending of the
orientation of the speakers: vertical or horizontal. See Fig.3.
Fig.3
Speaker Orientation
Switch
(OW-V41L model only)
