ELABO G1-1, Руководство по эксплуатации

Страница: 120 / 135

120
13. LITE SOFTWARE
13 ELABO Lite-Software
The ELABO Lite software provides different "simple" functions for the
control of the device and for the individual testing.
Help function: Prompts for the functions of the Lite software can be dis-
played over the F1 button.
13.1 CommandLine Tool:
The control commands are listed in the separate manual "Remote control/
Serial remote control G1-G7-series"
13.2 Flash-Programer for Firmware Update
- Control module (G1-1G and G1-1 T)
- Touch display module (G1-1G)
Attention: The firmware update must be carried out via the correct inter -
face.
- Control module via the service interface X9a (X9a)
- Touch display module via interface X9 (Ethernet, USB, RS232)
If the firmware is transferred to the wrong module, the device is no
longer able to work. In this case you can transfer again the right
firmware with the Flash programmer of the Lite software and such
overwrite the wrong entry (pay attention to the right interface).
13.3 Driver test (Treiber Test)
Over this function, single tests can be executed, with individual parameter
settings. E.g. HV, ISO tests are possible dependent on the device and its
equipment.
The software shows the results of the individual test on the field "Results".
Note: For the execution of individual tests there must exist a physical
connection to the unit (interface X9).
13.4 Result Explorer/Messwertspeicher auslesen
The function permits the selections and display of the stored results of
the tests (measured data storage). To be able to use the function, the
measured data storage must be set to "ON" in the "Setup" of the device
(see chapter 10 Setup)
Full-electronic G1-1 HV DC-Tester