- 5 -
STEP 6
Install your fittings to the water block and pay attention that the
inlet port is now on the right-hand side (closest to the stand-out). EK
recommends the use of EK-Quantum Torque fittings.
STEP 6
STEP 5
Push the black acetal stand-out back to its original position and screw
back the M4 x 22 screw that was removed at Step 2.
If the water block does not fit or the stand-out will not
return to its original position, this could be due to the
misalignment of the CPU block. Loosen the four (4) thumb
nuts so that the CPU block is free to move and temporarily
position the bridge block. Lastly, re-tighten the four (4)
thumb nuts and start over from Step 4.
STEP 5
M4 x 22 Screw
Black acetal
Stand-out
Thumb Nut
INLET
EK-Fitting