ekwb EK-Quantum Convection M.2 NVMe, Руководство пользователя

Страница: 7 / 11

- 7 -
SETTING THE HEATSINK CONFIGURATION
The Aluminum Cover has two alignments of holes. The first hole
alignment is dedicated for installing the Single-Sided M.2 SSDs,
which means all the storage and controller electronics are placed
on one side of the drive PCB. The heatsink comes out of the box in
the same configuration. The second hole alignment configuration
provides additional clearance for Two-Sided M.2 SSDs, which have
chips on both sides of the PCB. This configuration can be achieved
by flipping the backplate and aligning the backplate with the second
position of the threaded holes as shown in the picture below.
STEP 2
CUTTING AND PLACING THERMAL PADS
Your M.2 NMVe Heatsink came with more than an adequate amount
of thermal pads.
CAUTION: You must remove the protective foil from both
sides of the thermal pad before installation.
Thermal Pad G 1.0 mm – (120 x 24 mm) EAN: 3830046996770
Thermal Pad G 0.5 mm – (120 x 24 mm) EAN: 3830046996763
EK recommends cutting the provided thermal pads to the size most
optimal for M.2 NVMe drive coverage. The size shown below is most
commonly used, but we recommend cutting it in size to cover all the
storage and controller electronics on your M.2 NVMe SSD drive.
Thermal Pad G – 1.0 mm (120 x 24 mm)
120 mm
2
4 mm
1.0 mm
Thermal Pad G – 0.5 mm (120 x 24 mm)
120 mm
2
4 mm
0.5 mm
20 mm
70 mm
Most commonly used size