Page 1 of 8
Version 1.0
11/08/01
Abstract
This Application Note describes the differences between the CPC710-100+ (DD2) and the
CPC710 (DD3.x) versions of the PowerPC Dual PCI/Memory Controller companion chip. The
purpose of this note is to provide designers with an overview of the changes and point out
performance enhancements and potential programming changes. For a detailed
understanding of the operation of the CPC710-133, please refer to the User’s Manual. For a
detailed understanding of the physical pin out and electrical specifications, please refer to the
Data Sheet.
Overview
The IBM25CPC710 DD3.x is a host bridge that interfaces a PowerPC 60x bus with system
memory (SDRAM) and two independent PCI interfaces. It provides arbitration for one to
four
processors and supports up to two levels of pipelining per processor with 64-byte buffers
(maximum of 6 buffers). Use of external slave devices on the 60x bus is also supported and
requires additional external logic. The CPC710 DD3.x supports 60x bus speeds of up to 133MHz
at 2.5V.
Of course, given signal quality issues with higher bus speeds it is not recommended that
the CPU bus run at 133Mhz in configurations that include more than 2 CPUs.
The bridge’s two way interleaved memory controller supports SDRAM at 100 or 133 MHz;
both single bank and dual bank, PC100, PC133 and registered DIMMs are supported. The
memory controller design requires the use of an external multiplexer and two physical DIMMs.
The bridge contains two PCI host bus bridges: one provides an interface for a 32-bit, 33 MHz
PCI bus for standard and native I/O. This bus supports either 3.3V or 5V logic level devices, and
allows attachment of up to 2MB of boot ROM (and up to 256MB of extended boot ROM). The
other PCI interface supports a 32- or 64-bit, 33 or 66 MHz PCI bus for high data throughput, but
supports only 3.3V logic level devices.
This is a change from the previous revision
.
Burst and
non-burst data transfers to memory from the PCI (bridge acts as target on PCI bus) and from
memory to the PCI (bridge acts as master on PCI bus) are supported; data transfers directly
between PCI-32 and PCI-64 are not supported
.
This is a change from the previous revision.
A single channel DMA controller provides support for large data transfers between
memory and the PCI busses. DMA to and from the CPU bus to memory, or between PCI-32 and
PCI-64 is not supported.
This is a change from the previous revision.
IBM25CPC710 Bridge Chip:
Enhancements and Changes in the
DD3.x revisions
November 8, 2001
Version 1.0
PowerPC
TM
Applications
IBM Microelectronics
Research Triangle Park, NC
http://www.chips.ibm.com
