All disclosures, notices and warranty conditions are being written on the back of the box.
Released on 7
th
of May, 2010.
3. PLACING BLOCK TO GRAPHIC CARD. During this process please make sure you align
holes on PCB with holes on block. Also pay attention not to use too much force by
pressing block down to PCB. Chips are prone to cracking.
4. ATTACHING BLOCK TO GRAPHIC CARD. By using Philips screwdriver screw in
enclosed M3x8 screws. EKWB recommends start screwing the screws around the GPU
core and continue outwards.
STEP 4: CHECKING FOR CONTACTS
Temporarily remove the water block to check for uniform surface contact between the block and the components. Note the pattern of contact on a piece of paper. Then repeat
substeps in previous section to reattach the block. In case you can’t get good contact, please check again your thermal pad thickness our contact our support service.
STEP 5: POSITIONING FITTINGS AND OPTIONAL LINK
EKWB recommends using high flow fittings with the EK-FC 5870 series water blocks. To ensure that the tubes are securely attached to the barb/fittings, please use hose clamps
or an appropriate substitute. The use of an algaecide is always recommended for any liquid cooling system.
You can use any hole as an inlet/outlet hole.
User can also use enclosed link to make CF connection or to use additional angle to attach fittings.
STEP 6: INSERTING CARD IN YOUR PC CASE
Carefully lift your card with installed block and insert it in your PC case. Please bear in mind that your card suddenly withstands extra weight thus again be very careful not to
bend it or cause any other unneeded moves that might damage your card or block during installation.
REQUIRED TOOLS AND MOUNTING SCREWS:
scissors
philips scredriver
9 x screws M3x8 DIN7985
Note: Pictures of graphic cards are property of the
and are used with their permission.
Link with G1/4 threads
Use 9 screws M3x8
Fitting
Gaskets
M4x20
M4x20
M4x25
