All disclosures, notices and warranty conditions are being written on EKWB website.
Revision 1. Released on 5
th
of Merch 2019
STEP 4: PREPARING CPU AND APPLYING THERMAL GREASE (TIM)
STEP 5: INSTALLING THE WATER BLOCK
STEP 6: CONNECTING THE WATER BLOCK TO THE COOLING LOOP
Cleaning the CPU:
Wipe the CPU
’s contact surface
(by using non
–
abrasive cloth or
Q-tip
).
Applying thermal compound:
EK recommends a blob or line method
of applying the enclosed EK-TIM Ectotherm
™ thermal
compound to the
CPU heatspreader (IHS) - see sample photo on right. The quantity of
about pea size is just about right. There is no need to cover the whole
IHS. Applying too much thermal grease will have negative impact on the
cooling performance!
1) On majority of motherboards the EK-Annihilator Pro ILM can be
sucessfully installed with motherboard already being pre-fitted to the
computer chassis. Still, it is best practice to place a motherboard on an
even surface with front side facing up.
2) Install CPU and apply TIM (thermal grease) as shown in STEP 5
3) Align water block above the LGA 3647 socket on motherboard with
pre-installed CPU.
4) Tighten the screws using 4mm Allen Key the cross pattern.
5a: Tightening sequence:
You have to tighten the screws in cross pattern sequence using 4mm
Allen Key. Screws 1 and 2 must be tightened until they hit the limiter
and are not able to turn more.
Do not overtighten the screws 3 and 4!
1
2
3
4
Step 6a: Connecting G1/8 fittings with tube:
Carefully identify the direction of the flow in your circuit. EK recommends the
use of EK-HFB Fitting 6mm G1/8 and EK-Tube ZMT 6/9mm Matte Black tubing.
1. Install Barb 1/8 [1] to the CPU block by using 3/16 Allen Key.
2. Mount Clamp [3] to the tubing [2]
3. Mount the tube [2] to the barb [1]
Step 6b: Connecting G1/4 fittings with tube:
Carefully identify the direction of the flow in your circuit. EK recommends the
use of EK-HFB 10 mm barb fittings and
EK-Tube ZMT 10/16mm
.
The use of biocide containing and corrosion inhibiting coolant is always
recommended for any liquid cooling system. EK recommends using EK-CryoFuel.
1
2
3
