DRAFT
6. terminal BlocK Wiring
8. rePlacing tHe Battery
7. maintaining yoUr sm leDire iii lUminaire
Wiring schematic for the terminal block used with the Surface Mount Ledfire III is illustrated below.
1.
Use only the LiFePO4 battery recommended on the label found on the inverter/battery charger pack.
No other battery will work in this fitting, other than the type listed.
2.
Access the battery by removing the product cover as shown in
section 4 (page 3)
of this manual.
3.
Disconnect the battery from the product and if necessary, cut cable ties to release the battery from its
mounting position.
4.
Replace the battery as was previously installed and then reinstall inverter/battery pack or install as per all
relevant standard requirements.
5.
Replace the Surface Mount Ledfire III back into its previously mounted ceiling position and ensure the
green charge light is illuminated. Allow a few minutes for the battery to charge.
6.
Allow a minimum 24 hours charging time before carrying out any discharge tests as per the requirements
in AS/NZS 2293, BCA or other relevant standards.
Figure 4: Wiring schematic
The Surface Mount Ledfire III is connected to an unswitched active during normal operating conditions.
When disconnected from the mains supply, the Surface Mount Ledfire III is powered by a LiFePO4 battery
operated inverter. Due to this, care should be taken when replacing the battery.
WARNING
L N L' DA2 DA1
5
