Ekopower EkoHeat 1500, Руководство пользователя

Страница: 11 / 23

Page 11
Type Description
The ash plate Once a month or on demand the spindle for the ash plate must
be lubricated with KEMA RG 1100 aluminium paste.
Stop the boiler and press
menu/clean now/5 then the ash plate will
run 5 times and the burner pipe is cleaned for ash. Now unscrew the
4 Allen screws, which are placed opposite the engines in both sides.
Now pull the engines 10 centimeters backwards. The spindle which
is placed on the lower engine can be lubricated now. When you push
back the engines take care that the electrical igniter, which is placed
between the auger topmost and the spindle lowest, is placed
correctly in the tube.
Slag can occur on the ash plate if there are lots of impurities in the
pellets. If this is the case demount the yellow and the red wire on the
micro switch and the thermic sensor, and the ash plate can be taken
out and the slag can be removed.
Photo sensor Once a month check the photo sensor for dirt on the eye.
Pull it carefully out of its holder and clean the glass part with a cloth
with some cleaning material.
The pipe which holds it must be blown clean with a bike pump or
very softly with a compressor.
Put gently back in place until you hear a small click. If it does not
give a click turn the head of the photo sensor so the small
projection is turned against the middle of the burner.
Flue box Each half year , check the flue box and the flue ducts. If necessary
clean the flue ducts with a cleaning brush and empty the flue
box with an ash vacuum cleaner.
Turn off the boiler and unplug it, wait until the boiler cools down.
Demount the top plate of the boiler. At the back of the boiler the
flue sucker is placed with 4 butterfly nuts which are demounted.
The flue sucker is demounted and beneath this a loose cover plate is
placed which you remove. Now you can do the cleaning.