EKO MP-11, Инструкция по эксплуатации, Страница: 62 / 96

EKO INSTRUMENTS CO., LTD. I-V Curve Checker MP-11 Instruction Manual Ver.7 Pg. 61
Table 9-1. Measure Tab Functions - Continued
No Functions Details
5 General Button Setup measurement conditions
6 Parameters Button Setup PV modules or arrays parameter setting
7 Irradiance Sensor Button Setup pyranometer setting
8 Temperature Button Setup temperature setting
9 Load Parameter File Button Upload saved parameter file
10 Save Parameter File Button Save the setting contents in a file
11 Always on top Checkbox Check here to have this window always on top on the desktop
12 Save Data Checkbox Automatically save data
13 Use Sensor Unit Checkbox Check here when using the Sensor Unit
14 Automatic CSV file generation
Checkbox
Check here to automatically generate CSV file
15 Manual Range Settings Checkbox Check here for manual operation and enter the rating voltage/current
16 Manual Graph Scale Checkbox Check here and enter values to assign the graph range
17 Main Unit FW Ver.*
Sensor Unit FW Ver.**
Indicate firmware versions of MP-11 Main Unit and Sensor Unit
18 Set Clock Button Synchronize the clock on the MP-11 Main Unit and connected
Sensor Unit with PC clock
19 Exit Button Finish the application
*The firmware version numbers are indicated when the PC/software makes communication first time with the
MP-11 (for setting and file upload).
**If the Sensor Unit is not connected or not powered ON at the time of itinial firmware version read out, the
Sensor Unit firmware version will not be indicated. The firmware version information will not be read out in
any other communications after the initial read out.
1) General Setting
When [General] button is clicked, below dialog window appears.
(1) Select Communication Port (COM port No.) COM1 to COM16 are available.
If all COM ports are occupied by the other
applications already installed in the PC,
COM port number above 16 may be
assigned automatically and in some cases
the COM number does not show; in such
case, change the COM port number from the
Device Manager.
Figure 9-3-2 General Setting