EKO MP-11, Инструкция по эксплуатации, Страница: 39 / 96

EKO INSTRUMENTS CO., LTD. I-V Curve Checker MP-11 Instruction Manual Ver.7 Pg. 38

Not using the Sensor Unit to take measurements:
After the
“Powering on Sensor Unit” warning message appears on the start screen, press any key to
remove the warning message; the Main Menu screen is displayed and operation is available.
There is
“NO SU” indicated at the right top on the Main Menu. (See [8-4. Setting Menu] > [2.
Measurement Parameter Setting] for more details)
NOTE: If the time synchronization between the Sensor Unit and the Main Unit did not succeed, the Main
Unit may not be able to read the Sensor Unit data or may read the unmatched data from the Sensor Unit.
4. Powering OFF the MP-11
To turn OFF the MP-11 power, press and hold the POWER key for a while.
The power is turned off after
“Shutdown Running”
NOTE: Always make sure the there is no messages displayed on the LCD display after powering OFF.
8 - 3 . M a i n M e n u & M o n i t o r i n g S c r e e n
1. Main Menu Screen
After the Start Screen, Main Menu screen appears.
MEASURE: Starts measurement right away by pushing this button.
(Wait for more than 30 seconds between each
measurement)
CONFIG: Goes to each configuration setting menu.
DATA: Goes to display menu for measurement data.
Each function can be selected by pressing each [DATA], [CONFIG], and [MEASURE] button.
SU: Sensor Unit is selected
O : The Main Unit has completed the connection with Sensor
Unit
(NOTE: [O] appears around 5 seconds after the Sensor Unit is
connected and the Main Unit has recognized the Sensor Unit.)
NoSU: Sensor Unit is not selected
X : There is not connection with Sensor Unit
Battery Status Gauge
Main Menu Screen
MP-11
DATA CONFIG MEASURE
SELECT
〇
SU
Sensor Unit Connected
MP-11
DATA CONFIG MEASURE
SELECT
×
NoSU
Mp-170
DATA CONFIG MEASURE
SELECT X NoSU
Sensor Unit NOT Connected