EKKO Walkie EB16EA, Руководство по обслуживанию

Страница: 7 / 28

5
The vehicle can’t be
operated
Battery is charging
Full charge the battery, then unplug
the main power plug from the outlet.
Battery disconnected Connect battery correctly.
Fuse malfunction Check and replace the fuse.
Low battery Charge the battery
Emergency switch is activate
Unplug the emergency switch
The handle is not in operating area
Move the handle to the braking
area.
The vehicle drive to one
direction
Accelerator and connector are damaged Check the accelerator and connector
The vehicle move slowly
Battery discharging
Check the battery condition on the
discharge monitor
The electromagnetic brake has been
activated.
Check the electromagnetic brake
The handle wiring harness isn’t connected
or damaged
Check the handle wiring harness and
connector
At the 400mm altitude, the speed decreases
and the sensor fails
Check the sensor
Electric system overheated Stop using and cool the vehicle
The thermal sensor fails
Check, replace the thermal sensor if
necessary
The vehicle suddenly
start
Controller damage Change the controller
The accelerator has not moved back to the
middle place.
maintain or replace accelerator
If the vehicle malfunction and can’t operate outside work area, please hold up the vehicle, and place a load
handing device under the vehicle and make sure it is secure , then move the vehicle from channel.
b. Fault code display
1
、
Steering fault code