Page 23 of 25
●
Stay alert.
Pay attention to what you are doing. Take a serious approach to your work. Do not use the electrical
device if you are not focused.
●
Avoid unintentional starts.
Ensure that the switch is turned off when you insert the plug into the socket.
●
Take the plug out of the socket.
Take the plug out of the socket when carrying out any of the work described for taking the device into
operation and carrying out maintenance or repairs, when changing tools, and when the device is not in
use.
●
Use the correct device.
Only use the engraving unit with a plotter (electrical device) for the purposes described in the manual.
●
Secure the material which is to be worked on.
Ensure that the universal mounting plate has sufficient adhesion, and clean it regularly under running
water. Only use mounting plates manufactured exclusively by EK-TEAM for mounting the material which
is to be worked on.
●
Never try to take hold of moving (rotating) parts.
●
Do not overload your electrical devices.
You will work better and more safely in the performance range indicated. Replace worn tools in good
time.
●
Look after your tools carefully.
Keep the tools sharp and clean in order to work better and more safely. Follow the maintenance
instructions and the instructions for changing tools. Check the cable of the electrical device regularly,
and have it replaced by an approved specialist if it becomes damaged. Check the extension cable
regularly and replace it if it becomes damaged. Keep the devices dry and free of oil and grease.
●
Store your electrical device safely.
Unused electrical devices should be deposited or stored in a dry place, off the ground or locked away,
out of reach of children.
●
Caution. Follow these instructions without fail
For your personal safety and to secure the intended function of the electrical device, use only original
accessories and original spare parts. The use of other tools and other accessories may incur the risk of
injury for you. Only allow the electrical devices to be repaired by an authorized EK-TEAM Service
Centre. This electrical device meets the relevant safety regulations.
Maintenance and repair work, in particular interventions into the electrics, may only be carried out by
specialist or trained personnel, making use of original spare parts; this may otherwise incur accidents
for the user.
For safety reasons, no modifications may be carried out on the electrical device by users
themselves. This will lead to any claims against the manufacturers being rendered null and void.
●
Special safety instructions regarding the operation of the engraving spindle.
The engraving spindle may only be operated in the engraving head provided for that purpose. During
operation, temperature increases occur at the spindle, which must be taken into account in particular
when replacing the engraving needle.
It is therefore recommended that the spindle be allowed to cool off after operation before the
engraving needle is replaced or the engraving head is dismantled.
