Page 13 of 25
5.7 HIGH / LOW penetration speed
When engraving data are transferred from the PC to the engraver, the penetration
speed will also be automatically transferred. If you want to change these data during
the engraving process, you can change the speed by means of the appropriate
buttons.
By actuating the
HIGH
button, the penetration speed will be increased by 2 mm/sec.,
and by actuating the
LOW
button it is reduced by 2 mm/sec.
Note:
The adoption of the speed change takes place with a slight delay.
5.8 Placing support plates for fixing the engraving materials
There are a number of different support plates optionally available for fixing the
engraving material. Place the support plate being used over the retaining pins on the
engraving unit.
1) Universal support plate DIN A4/A3 (adhesion mat)
The universal support plate is suitable for materials up to
dimensions of 400x300 mm. The thickness of the material must not
exceed 2.5 mm.
The adhesion mat secures the engraving material against sliding.
2) Universal support plate DIN A4 with vacuum connection
The universal support plate is suitable for materials up to
dimensions of 200x300 mm. The thickness of the material must not
exceed 2.5 mm. The support plate has a vacuum connection
to which you can connect an in-house vacuum line.
As an option, we can offer a vacuum pump or a converter
which produces a vacuum out of compressed air
(see Accessories).
3) 3-fold Universal support plate
You can process three engraving plates on this support plate, up to
dimensions of 90x100 mm. Material thickness up to 2.5 mm.
4) 4-fold Universal support plate
You can process four engraving plates on this support plate, up to
dimensions of 60x100 mm. Material thickness up to 2.5 mm.
5) 9-fold Universal support plate
You can process nine engraving plates on this support plate, up to
dimensions of 30x100 mm. Material thickness up to 2.5 mm.
