- 12 -
STEP 4
PLACING THE BLOCK ON THE GRAPHICS CARD
Carefully position the water block with preinstalled standoffs on
the graphics card. During this process, make sure you have aligned
mounting holes of the PCB with holes of the water block (the same
applies to other tops).
Pay attention not to use too much force when pressing the
block down to the PCB since chip dies are prone to cracking.
Before placing the Water Block, make sure all the Thermal
Pads are placed correctly!
STEP 4
For this step, you will need:
M 2.5 PVC Washer
(4 pcs)
M2.5 x 4 AX1
Screw (4 pcs)
Phillips Head
Screwdriver
4 mm
STEP 5
M2.5 x 4 AX1 SCREW
M2.5 PVC
WASHER
STEP 5
ATTACHING THE BLOCK TO THE GRAPHICS CARD
Use four (4) M2.5 x 4 AX1 screws and M2.5 PVC washers, as
shown in the image. Tighten the screws around the GPU core
evenly using the Phillips head screwdriver. Always use a plastic
washer under each screw!
