- 11 -
STEP 2
REMOVING THE PRE-INSTALLED I/0 BRACKET
Unscrew the three (3) M3x5 screws using Phillips head screwdriver and
remove the I/O Bracket (as shown in the picture). Save the screws and
I/O Bracket for the later use!
For this Step, you will need:
STEP 2
M3 x 5 SCREW
Phillips Head Screwdriver
I/O
BRACKET
STEP 3
PLACING THE BLOCK ON THE GRAPHICS CARD
This procedure is the same for all full-cover water blocks.
Carefully position the water block with preinstalled standoffs on
the graphics card. During this process, make sure you have aligned
mounting holes of the PCB with holes of the water block (the same
applies to other tops).
Pay attention not to use too much force when pressing the
block down to the PCB since chip dies are prone to cracking.
STEP 3
