Page 3 of 12
Drawing : - TPC509
Issue
: - 1
Date
: - 29/01/20
INTRODUCTION
Designed for a wide range of applications, the CD35SP is a rugged, compact
unit which incorporates its own tank for collected moisture with an automatic
shutoff once the tank is fully. Offices, shops, houses, restaurants and
storerooms can be protected by this simple answer to humidity control.
The CD35SP has a number of special features:
•
Adjustable humidistat
•
“Hot Gas” defrost system
•
Whisper-quiet fan
•
Water tank with “full” indicator lamp
•
All galvanized interior
•
Exterior epoxy powder-coated finish
•
Four independent heavy-duty castors
•
Fully enclosed coils
The fan draws the moist air through the cold evaporator coil, which cools the
air below its dew point. Moisture forms on the evaporator coil and is collected
in the condensate tray, which is equipped with a permanent drain. The cooled
air then passes through the hot condenser coil where it is reheated using the
same energy removed during the cooling phase, plus the additional heat
generated by the compressor. The air is, therefore, discharged from the
dehumidifier at a slightly higher temperature with a lower absolute humidity
than that which entered. Continuous circulation of air through the
dehumidifier gradually reduces the relative humidity within the area.
The CD35SP dehumidifier is a rugged, reliable drying unit designed to
operate effectively over a broad range of temperature and humidity
conditions. An active hot gas defrost system, controlled by an electronic
timer, guarantees positive de-icing, thereby optimizing operation at low
temperatures.
The unit incorporates a welded and galvanized steel chassis and is finished in
an epoxy coating for resilience to damage caused by rough handling.
The CD35SP dehumidifier is fitted with an adjustable humidistat to enable you
to select the level of dryness that you desire.
