EINBREW.COM
EINBREW 1V1P USER INSTRUCTIONS
V1.0.6 © ACKSEN LTD 2017
24
BREWING WORT
Pre-Heat/Mashing In Stage
Now that you’ve entered your recipe, you’re ready to start! Add your water to the
vessel as
necessary, and press the
Stage
button until the
Pre-Heat
section is selected. Confirm that the
temperature displayed is correct, and press the
Start
button to begin!
The heater will automatically operate until the temperature matches the one you’ve set. If you need
to, you can use the Up/Down buttons in the temperature
section to change the set temperature
dynamically.
IMPORTANT: You must manually start the Pump during brewing. This is especially important if
you are using a RIMS system, as it can be dangerous to operate the heater without the pump and
water circulation.
Once the temperat
ure has been reached, the bottom half of the timer display will indicate ‘END’,
and the alarm will sound. Press the
Alarm
button to silence the alarm.
You can now add your grain to the vessel.
Mashing Stage
Press the
Stage
button until the
Mash
section is selected, then press the Start button. EINBREW EBC
will automatically run through the Mashing Phases that you’ve setup previously. You’ll see that the
indicator will heat through each temperature step, and once that’s reached the timer will start
counting down.
The
Timer
section will show you the remaining time in the top half, and alternate between showing
you the Mash Phase (Ph 1 to Ph 9
) and the total time you’ve set for the Phase in the bottom half. If
you need to, you can use the Up/Down buttons in the
Timer
and
Temperature
section to change the
set time and temperature dynamically.
Once all the phases that you’ve setup have been completed, the bottom half of the timer display will
indicate ‘END’ and the alarm will sound. Press the
Alarm
button to silence the alarm.
The grain can now be removed from the vessel.
Boiling Stage
Press the
Stage
button until the
Boil
section is selected, then press the Start button. EINBREW EBC
will automatically heat to the temperature you’ve setup previously, and
then the timer will start
counting down.
You can use the Temperature Up/Down arrows to change the Boil temperature dynamically when
you’ve reached the set temperature point –
you’ll need to experiment to see what’s best for your
system, depending on how strong a boil you want!
