Setting
Capture
Capture
This function enables you to capture an image being
projected to use it for a starting-up display or interval of
presentations.
Select
Capture
and press the SELECT button.
A confirmation box appears and select
yes
to capture the
projected image.
After capturing the projected image, go to the Logo select
function and set it to
User
. Then the captured image will be
displayed the next time you turn on the projector.
To cancel the capture function, select
yes
in the "Quit?"
confirmation box.
Note:
• Before capturing an image, select
Standard in the
Image Select Menu to capture a proper image (pp.40,
46).
• A signal from a computer can be captured up to
WUXGA (1920 x 1200).
• When capturing the image that has been adjusted
by the Keystone function, the adjusted data is
automatically reset and the projector captures an image
without keystone correction.
• When
Logo PIN code lock is set to On, Capture
cannot be selected.
• When starting to capture a new image, the previously
stored image is cleared even if you cancel the
capturing.
• When there is no captured image or it is interrupted
while capturing an image,
User can not be selected,
you can only switch between
Default and Off.
• Capture function is not available when the Picture in
Picture function is set to
User 1-5
.
Logo PIN code lock
This function prevents an unauthorized person from
changing the screen logo.
On
.......... The screen logo cannot be changed without a
Logo PIN code.
Off
......... The screen logo can be changed freely from the
Logo Menu (p.52).
If you want to change the
Logo PIN code lock
setting,
press the SELECT button and the Logo PIN code dialog
box appears. Enter a Logo PIN code by following the steps
below. The initial
Logo PIN code
is set to "4321
"
at the
factory.
Logo PIN code lock
53
