Note:
• Factory default is
Ready: 5 Min.
• When the shutter is closed while the Power management
function is working, the Power management function is
released.
Setting
Select a location of the infrared remote receiver of the
remote control. See “Remote Control Receivers and
Operating Range” on page 15 for details.
All
.......................Activate all of the receivers.
Front & Top
.......Activate both the front and top receivers.
Top & Back
........Activate both the top and back receivers.
Front & Back
..... Activate both the front and back receivers.
Front
..................Activate only the front receiver.
Top
.....................Activate only the top receiver.
Back
...................Activate only the back receiver.
No signal
4 : 50
Timer left before Lamp is off.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready
.............. When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp will be turned on if the
input signal is reconnected or any button
on the side control or remote control is
pressed.
Shut down
...... When the lamp has been fully cooled
down, the power will be turned off.
Off
................... Power management function is off.
Timer
............... If the input signal is interrupted and
no button is pressed for more than 30
seconds, the timer display with
No signal
appears. It starts the countdown until the
lamp is turned off. Use the Point ▲▼
buttons to set the Timer (1~30 Min).
This function is available when operating the projector via
network.
Network
. . . .Supply the power to the network function
even after turning off the projector. You can
turn on/off the projector via network, modify
network environment, and receive an e-mail
about projector status while the projector is
powered off.
Eco
............... Select
Eco
when you do not use the projector
via network. The projector’s network function
will stop when turning off the projector.
Refer to the owner’s manual of “Network Set-up and Operation”.
Note:
• Factory default is
Network.
• When selecting
Network, the cooling
fans may be running depending on the
temperature inside the projector even if
the projector is turned off.
• When
Eco is selected and the projector
is in Stand-by, the communication of
RS-232C serial port is not available.
RC sensor
Power management
Standby mode
59
