37
8. What to do if...
Danger!
When working at the
fi
lter, assure that no water gets into contact with electrical interfaces.
Disconnect the power plug! In case of problems, visit our website www.eheim.de.
Cause
Solution
Filter inserts have been
inserted wrongly.
Push
fi
lter inserts and pre
fi
lter in until they lie
fl
ush on top of each
other.
Filter inserts are too full.
Do not over
fi
ll
fi
lter inserts. If need be, clean the touching surfaces.
Partition not
fi
tted properly.
Push partition into the
fi
lter container until it engages correctly.
Gasket not
fi
tted properly.
Insert correctly into the groove provided in the upper part of the
fi
lter.
Check for damage and if necessary replace.
...Top part of
fi
lter can’t be closed
Cause
Solution
Closing clips not closed
properly.
Close all clips properly.
Sealing areas or gasket
soiled.
Clean seal areas and spray lightly with
EHEIM
-silicon grease spray
Order No. 4001000.
Sealing ring not
fi
tted,
inserted wrongly or
damaged.
Insert sealing ring correctly or renew.
...Top of
fi
lter leaks
Cause
Solution
Pre-
fi
lter
fl
ap in pre-
fi
lternot
closed.
Check the pre-
fi
lter
fl
ap for pollution and, if required, clean it. The
pre-
fi
lter
fl
ap must be unobstructed (see chapter 7.3, step 13).
Pre
fi
lter is
fi
lled with water.
Empty pre
fi
lter and repeat priming. Priming only works when the
pre
fi
lter is empty.
Check valve polluted/
defective.
Clean and, if required, replace the check valve (see chapter 7.3).
...Primer does not work
Ursache
Behebung
Keramikhülse nicht oder
falsch eingebaut.
Keramikhülse richtig einbauen, ggf. ersetzen.
Keramikachse gebrochen.
Keramikachse erneuern.
...die Pumpe sehr laut läuft?
english
