ehb SMARTdisplay 101
Operating Instructions
©
ehb Errors excepted
Vers. 1.2
7
/
19
2.
Operation
2.1 Connection
The
ehb SMARTdisplay 101
is mounted using the holders supplied and four plastic bolts. The electri-
cal connection to the
device
is via a DEUTSCH plug, DT 06-12S.
Figure 1: Wiring diagram and pin assignment
*
The
out
pin 11 is only available on devices with serial number 372153 or higher.
For setting up and for software updates, etc., a standard USB cable can be attached to the USB port
and a standard CAT.5 patch cable connected to an Ethernet socket. For operation of the unit, cables
with the appropriate LTW connectors must be used. If you are not intending to use these interfaces,
the cap supplied should be fitted. Otherwise, the device will not meet the IP 67 protection class.
Pin / Contacts
1
GND
2
Kl. 30
3
AuxIN2
4
AuxIN1
5
GND
6
GND
7
CAN1_L (Bus 1 in Application)
8
CAN1_H
9
CAN2_L (Bus 0 in Application)
10
CAN2_H
11
OUT Kl. 15F
12
Kl.15
*
