Eguana ACB05U-LP, Инструкция по установке и запуску, Страница: 17 / 29

14
9.2 PCS display panel indicator summary
9.3 Service Button
The service button can be used to wake the LED display, and either place the system into or out of service mode, as
well as cycle through various operating modes. If the system has gone into service mode, the user can attempt to
bring the system back into normal operation using the service button.
Note: It is recommended to login to the EMS via web browser and retrieve the service code from the system prior to
attempting to clear the service mode.
Refer to section 11 – Troubleshooting if the service button does not perform the action requested.
9.4 Backup Power Operation
This system will provide backup power to dedicated electrical circuits within the home via a permanently wired
electrical sub-panel, referred to as the backup panel. Backup power is limited in rating and duration, both of which are
dependent on the nature of the loads connected to the system, and the availability of the solar PV supply. This system
is designed to reliably provide power to a refrigerator, home lighting, home electronics, and small appliances.
NOTE: This product is not an uninterrupted power source (UPS). Following a utility outage, a four second power
interruption will occur before the backup power source commences. As a result of this interruption, a desktop or
portable UPS is recommended if continuous operation is desired for any electronic devices.
IMPORTANT! Surge rated loads, ie) power tools, portable air conditioners, may cause an overload shutdown.
Equipment of this type that is connected to the backup panel should be inspected and tested regularly as per
manufacturer suggested schedules. Permanent damage to the battery system and/or your equipment may occur if
exposed to chronic overloading cycles.
LED
Mode
Definition
State of charge. Each LED represents 20%
SOC. Solid = battery idle.
Charge = flash right. Discharge = flash left.
Low battery.
Sleep / Standby mode.
Grid timing mode.
Grid synchronization mode. Ten second test
before grid connect mode.
Grid connected mode.
System OK.
System out of service.
User initiated service mode.
Observed state Action Service button command
All panel lights off Wake panel display Press and release
Service light on Exit service mode Press and hold 5 seconds

Blink
Flash
Solid