4. To install the horizontal stabilizers you first need to install two 42” servo wire extensions in the
fuselage so that they extend from the radio compartment to the aft openings. A servo wire tunnel is
provided in the fuselage to guide the wires.
5. Slide the stabilizer onto the two carbon fiber tube into the fuselage and install both stabs onto the two
tubes. Connect the servo wires and secure the connections with either the supplied clips or tape. Use
the supplied screws and rubber washers to secure the stabilizers to the fuselage.
WING AND AILERON CONTROLS ASSEMBLY:
1. Install the Carbon Fiber control horns in a similar fashion as described above. Again, make sure they
are properly aligned to each other and fully seated in their respective slots.
2. Cut the covering from the aileron servo openings from corner to corner and iron down inside the
openings. Connect servo wire extensions to your servos and secure the connections with the supplied
clips, your own clips, or tape. Feed the servo wires into the wing and out the root. Install the servos
and screw firmly in place.
