EFKA AB60D1472
66
Supplier Level
Code no. 311 with control operation
Parameter
Designation
Unit
max
min
Preset
Ind.
240 in1
Selection of the input functions on socket ST2/7
44 0
0
*) A
and B4/1 for input 1.
A value is preset for a number of
modes. See chapter “Preset Values Depending on Mode”
0
=
No
function
1
=
Needle
up/down
2
=
Needle
up
3 =
Single stitch (basting stitch)
4
=
Full
stitch
5 =
Needle to position 2
6 =
Machine run blockage effective with open
contact
7 =
Machine run blockage effective with closed
contact
8 =
Machine run blockage unpositioned effective
with open contact
9 =
Machine run blockage unpositioned effective
with closed contact
10 =
Automatic speed n12 without pedal
11 =
Limited speed n12 pedal controlled
12 =
Sewing foot lifting with pedal in position 0
(neutral)
13 =
High lift for walking foot with speed limitation n10
(operational mode not stored)
14 =
High lift for walking foot
(flip-flop 1)
with speed
limitation n10 (operational mode stored)
15 =
Tape cutter / fast scissors
(in chainstitch and overlock mode)
16 =
Intermediate backtack / intermediate stitch
condensing
17 =
No function
18 =
Unlocking the chain (can be activated by
keystroke, but will be executed only at the
seam end)
19 =
Set counter of bobbin thread monitor
20 =
Positioning speed n1
21 =
Reversal of motor rotation (possible only if
parameter 290 = 12)
22
=
No
function
23 =
Speed limitation n9
24 =
Needle moves from position 1 to position 2
(flip-flop 3)
. If the needle is outside of position 1,
machine start is blocked for safety reasons and
the sewing foot is immediately lifted.
25 =
Speed limitation with ext. potentiometer
On/Off (see parameter 126)
26
=
No
function
27 =
Unlocking the chain (the function is performed
upon pressing the key).
28 =
External light barrier
29
=
No
function
30
=
No
function
31 =
Function “speed limitation bit0” (speed n11)
32 =
Function “speed limitation bit1” (speed n10)
(Bit0 + Bit1 = Speed n9)
33 =
Speed n9 pedal controlled
34 =
Automatic speed n9 can be suspended by
pressing the pedal to pos. 0
35 =
Automatic speed n9 can be interrupted by
pressing the pedal to pos. -2
36 =
Automatic speed n9 without pedal
37
=
No
function
38
=
No
function
*)
Depending on the selected mode. See table at the beginning of the List of Parameters!
