Efka DC 1550, Инструкция по эксплуатации

Страница: 32 / 52

Instruction Manual
- 32 -
Display after enabling machine run blockage without control panel:
Control display

Display and signal after enabling machine run blockage with control panel:
Display on the V810 control panel!

(symbol blinks and acoustic signal if parameter 127 = 1 )
Display on the V820/V850 control panel!
(symbol blinks and acoustic signal if parameter
127 = 1 )

Machine run blockage in the free seam, seam with stitch counting and light barrier seam:
The seam is suspended by opening and/or closing the switch.

Stop in the basic position

Needle up is not possible

Sewing foot lifting is possible
Machine run blockage in the start backtack / start stitch condensing:
The start backtack / start stitch condensing is interrupted by opening and/or closing the switch.

Stop in the basic position

Needle up is not possible

Sewing foot lifting is possible

After disabling of the machine run blockage, the seam will be continued with the section following the start
backtack / start stitch condensing
Machine run blockage in the end backtack / end stitch condensing:
The end backtack / end stitch condensing is interrupted, and the seam is completed by opening and/or closing
the switch.

Sewing foot lifting is possible
New start after machine run blockage
Function with or without control panel
Parameter
New start after machine run blockage (Pdo)
234
Parameter 234 determines how a new start is possible after closing and/or opening the switch.
234 = 0 New start after disabling machine run blockage without influence by the pedal. This setting is
applicable, for example, to automats
234 = 1 New start after disabling machine run blockage only if the pedal is in position 0 (neutral).
7.7 Stop function
A
TTENTION
This is not a safety function. The line voltage must still be switched off during maintenance and
repair work.
For this function, the red key S8 is provided in the multiple-function key bar on the machine head (parameter
847=24 ). However, any other input may also be programmed with this function.
When the key is pressed while the machine is running, the drive stops in position 2. If it is in position 1, it runs to
position 2. If it is already in position 2, it remains there.
No thread trimming is carried out. The thread clamp, thread tension release, and sewing foot lifting signals are
turned on. The machine run blockage is activated and the red LED above S8 turned on.
The machine run blockage is released after the
"E" key is pressed on the control panel. The sewing foot is
lowered or remains lifted regardless of the setting/programming selected. The seam may be continued at the
previously uninterrupted point.
A 2
-S t o P-