Efco swaploader SL-105, Руководство по эксплуатации и частям

Страница: 26 / 82

Section II: Installation
2.0.INS.SL-105
START UP PROCEDURE
1. Fill the hydraulic tank with hydraulic oil (see oil specification in Section IV: Maintenance.)
2. Prime the pump by loosening the clamp on the suction hose at the pump. Pull the hose
back off the fitting till the air is bled from the line. Push the hose back on the fitting and
retighten the clamp.
3. Engage the P.T.O. and run the pump at idle (700 to 900 RPM). Operate the cylinders at
full stroke five to ten times to bleed the air from the lines and cylinders. The cylinders
were filled with oil during testing at the factory, but some seepage may have occurred
during shipping and installation. Refill the hydraulic tank, if needed, during this
sequence and do not let the pump run without oil.
4. Check for leaks and tighten fittings as necessary.
5. Verify the movement of the control levers
corresponds to the movement of the
cylinders per the figure below.
6. Install all safety decals and product
decals per as shown on Pg. 1-5 after
final installation and painting have been
completed.
7. Fill out the Product Registration form
online at
https://www.swaploader.com/warranty-
registration/
CAUTION The SwapLoader hoist must be used with bodies or containers that properly
fit the front hook and the rear hold-downs. If possible, pick up one of the
containers that will be used with the SwapLoader hoist and verify the
following:

Outside dimensions of the long sills match the guiding rollers on the
hoist.

The front hook dimensions are correct for the hoist.

The rear hold-downs of the container latch into the hold-downs on the
hoist.

Check for any interference between the container and any part of the
hoist (i.e.: Hydraulic tank, hydraulic tubing or hose, hydraulic valve, etc.)
NOTE:
FAILURE TO FILL OUT AND SUBMIT PRODUCT REGISTRATION WITHIN 15 DAYS OF INSTALLATION MAY POSSIBLY
VOID THE WARRANTY.
2-14