EFA Z140, Руководство по эксплуатации

Страница: 23 / 33

Schmid & Wezel
D 75433 Maulbronn Seite/ Page
5/ 15
Ausführung/ Version
05.2004
pulley
The spring-loaded pulley can be adjusted by turning
the PLUS/MINUS screw at the housing (see Fig. 1).
Figure 1:Spring-loaded pulley
„
Turn the screw in MINUS direction until the tool
is balanced and suspended at the correct
height.
If it is not possible to pull more cable from the
pulley, it is jammed and must be readjusted.
„
Turn the screw in PLUS direction until cable can
be pulled from the pulley and repeat the fine
adjustment (see above).
5. Maintenance
Malfunctions that might occur during operation can
generally be eliminated by simple means. The most
common malfunctions, their causes and remedies
are compiled in Table 1: "Troubleshooting".
Table 1: Troubleshooting
Malfunction Possible cause Remedy
The switching lever and valve
arm are pressed, but the pump
and/or the cutter are not working
1. Unit is not switched on Switch on hydraulic unit
2. No power Check power supply and repair
When the switching levers are
pressed, the pump is started, but
the cutter remains open
3. Insufficient air pressure
Adjust air pressure at the unit to
minimum 5 bar (for hose length 5
m)
4. Control line defective
Check control line and replace, if
necessary
5. Two-hand safety block
defective
Inspect two-hand safety block
and replace, if necessary
6. Coupling adapter of the
hydraulic return hose not
properly connected
Check and reconnect hose
7. Seals defective
Check seals and replace, if
necessary
8. Hydraulic fluid level too low
Refill hydraulic fluid (see chapter
3.1.2 "Hydraulic unit" (page 3))
When the switching levers are
pressed, the pump is started, but
the cutter closes only very slowly
9. Fluid filter of pump blocked Replace filter and fluid
10. Hose coupling loose
Inspect couplings and hose
connections
Hydraulic pump is overheating 11. Gear pump defective Replace gear pump
Pump is running, but there is no
pressure at the cutter
12. Seals in the hydraulic pump
cylinder are defective
Replace seals; if necessary,
replace pump cylinder
Handle cannot be pressed
13. Valve defective
Replace valve (see chapter 4.2
"Replacement of valve" (page 4))
14. Valve blocked by dirt
Clean valve (see chapter 4.2
"Replacement of valve" (page 4))