EFA SB 288 E, Руководство по эксплуатации, Страница: 19 / 43

Schmid & Wezel
D75433 Maulbronn, Page / Seite
5 / 27
Version / Ausführung
08.2005
3.2.2 Switching OFF
„
Release the switch handles. The machine is
automatically switched off.
3.3 Working with the splitting saw
3.3.1 Cutting process
Prior to starting the saw, compare the technical data
of the power mains with that of the tool.
„
Hold the splitting saw with both hands by the
handles and switch it on.
„
Insert into meat while the saw band is running.
„
Remove the saw from the cut while the band is
still running and release the switching lever to
switch off the saw.
Never reach into the operating
range of the saw band as limbs
could be severed!
All installation work must be
carried out by suitably trained and
authorised technicians.
Always wear goggles or other
effective eye protection!
See also chapter 3.2 "Operation of switch" (page 4).
3.3.2 Operational safety
For safety reasons, the EFA SB 288 E is equipped
with two operating handles.
„
Hold the machine by the fixed handle and the
switching lever. Never attempt to operate it with
one hand.
„
While the tool is switched on, proceed with
extreme caution.
„
Never remove any safety devices to disassemble
the splitting saw.
„
For safe operation with proper guidance, the
splitting saw should be attached to a spring-
loaded pulley system.
„
When switched on, do not reach into the
operating range of the saw band.
„
Do not actuate the motor switch while inserting
the saw band.
„
Regularly check the suspension mechanism for
damage.
„
Adhere to the general safety instructions in
chapter 2 "Safety instructions" (page 3).
4. Installation and assembly
4.1 Changing saw band
The splitting saw is equipped with a switch-on
protection mechanism, so that it cannot be started
if one of the two covers is opened.
Before carrying out any assembly
work, disconnect the saw from the
power supply!
All installation and assembly work
must be carried out by suitably
trained and authorised
technicians.
The saw band may only be changed
after the machine has been
disconnected from the power
supply!
Never reach into the operating
range of the saw band as limbs
could be severed!