Eela Audio D3, Быстрый старт

Страница: 9 / 23

Eela Audio D3 manual, October 2009 8
AUX CONFIG:
The master settings for the 4 aux outputs:
Master AUX Configuration menu sets the AUX for ‘Pre’ or ‘Post’. If a Studio monitor check box is active
the Studio monitor DIM function is applied to this AUX upon opening a “Studio Microphone” fader.
SHUT DOWN:
The unit has a power switch in the back. It is recommended to use this switch to shut off the unit. If
the unit is flush mounted in a table or built in a 19” rack were you cannot reach this switch you can
shut down (sleep mode) the unit in software. By holding down the ‘settings’ rotary for 3 seconds the
unit will power up again.
Please note: From this state the unit will also switch on if the (mains) power was down and on again!
OUTPUT LEVELS: (MAIN SCREEN)
Selecting the OUTPUT LEVELS button in the main screen opens an overview of all output levels.
Touching a bar selects it and allows for level setting with the rotary. Turning the rotary will
immediately change the level, no need to confirm the setting by pushing on the rotary.
In this way you can still set the outputs levels of the main outputs without the faders assigned to
these outputs.
Please note: If a master fader is assigned to an output the level cannot be changed with the rotary.
Headphones and CR monitor rotaries are permanently assigned to these outputs.
NO OUTPUT FROM THE MIXING DESK: This screen is the first to look at!
Example: If you switch off a master fader while the fader is in closed position the main level of this
output will also be low. You can turn the volume up as described above.