Additional Features
Caption Absence Alarm
The Caption Absence Alarm feature, accessed from the Alarm section of the side menu of the encoder web
interface, allows you to set alarms to automatically alert you when caption presence is not detected on the
encoder for a certain amount of time. This is a useful feature for monitoring caption activity on your encoder.
Figure 8: GPI Alarm Settings on the Encoder Web Interface
Caption Input Blocking
You can block caption input to your encoder via the following non-relocation GPI functions found in the GPI
Settings on your web interface. They are as follows:
✔
Modem Lockout: Blocks caption input from the Modem
✔
P2 Lockout: Blocks caption input from Serial Port 2
✔
Force Regen: Blocks caption input from Modem, P2, and iCap
Capturing Incoming VANC or 608 Data for Analysis
You can capture and save VANC data from the master video input to a USB stick for review or troubleshooting.
Place a USB stick into the USB port on the front panel of your encoder and navigate to Utilities > Capture All VANC
from the front panel LCD. Press ENTER to begin downloading the VANC data or CANCEL to exit. To stop capturing
VANC data press any front panel key. Depending on the size/type of memory device used, there may be a
momentary delay before the device is detected. If you see “Failed: Insert USB Disk”, wait a few seconds and try
again. For questions about analyzing your VANC data. Please contact our support team at 516-293-7472 or
Copyright © 2021 EEG Enterprises, Inc.
28
All Rights Reserved.
