HD491 Smart Encoder
9 Copyright © 2000-2014 EEG Enterprises, Inc.
All Rights Reserved.
SD/HD Encode
SD/HD Encode allows you to use the aux path to simultaneously encode
matching captions to a synchronized source of SD Video. This feature is
off by default – to activate, select ‘SD/HD Encode’ by using the
UP
and
DOWN
buttons to scroll through the list. Set SD/HD Encode to “On”
and press
ENTER
to save your selection or
CANCEL
to exit.
SD/HD Encode option should
NOT
be used simultaneously with
CCMatch activated in external delay mode. Doing so will produce
undesirable results.
Utilities
Test Captions
The Test Caption menu allows you to enable a stream of caption text on
a single 608 channel of your choosing.
Enable
starts the stream of captions on the selected channel, which
is CC1 by default. To enable test captions use the
UP
and
DOWN
keys to select
ON
. To disable test captions select
OFF
. Use the
ENTER
key to apply the changes. The test captions will stop if any
other port (i.e. 232, modem or Linux virtual port) enters caption
mode on the same channel and automatically change Enable to
OFF
.
Set Channel
allows you to select which 608 channel the test caption
stream will be appear on. The default channel is CC1. TO select a
different channel use the
UP
and
DOWN
keys to select a different
channel and press the
ENTER
key to apply the change.
Capture VANC
Captures VANC data of the selected DID/SDID from the Master video
input and loads it onto a USB storage device. Use the
UP
and
DOWN
keys to select the desired DID/SDID and insert a USB device into the
box. Press
ENTER
to
begin downloading the VANC data or
CANCEL
to exit. To stop capturing VANC data press
any front panel key.
Depending on the size and
type of memory device used, there may be a
momentary delay before the device is detected.
If you see “Failed: Insert
USB Disk”, wait a few
seconds and try again.
