EDT PCIe Gen1 Framegrabbers, Руководство пользователя

Страница: 30 / 43

Camera Link PCI Express (PCIe) Gen1 Framegrabbers Appendix A: Pin Assignments
EDT, Inc. 2012 March 16 25
Appendix A: Pin Assignments
Table 5 shows the MDR26 pin assignments for Camera Link signals.
Table 5. Pinout – MDR26 Connector
Camera
end
Framegrabber
end
Camera Link signal
(base mode,
primary connector)
Camera Link signal
(medium mode,
secondary connector)
Camera Link signal
(full mode,
secondary connector)
1* 1* inner shield / ground* inner shield / ground* inner shield / ground*
14* 14* inner shield / ground* inner shield / ground* inner shield / ground*
2 25 X0– Y0– Y0–
15 12 X0+ Y0+ Y0+
3 24 X1– Y1– Y1–
16 11 X1+ Y1+ Y1+
4 23 X2– Y2– Y2–
17 10 X2+ Y2+ Y2+
5 22 Xclk– Yclk– Yclk–
18 9 Xclk+ Yclk+ Yclk+
6 21 X3– Y3– Y3–
19 8 X3+ Y3+ Y3+
7 20 SerTC+ unused 100 ohms
20 7 SerTC– unused terminated
8 19 SerTFG– unused Z0–
21 6 unused Z0+
9 18 CC1– unused Z1–
22 5 CC1+ unused Z1+
10 17 CC2+ unused Z2–
23 4 CC2– unused Z2+
11 16 CC3– unused Zclk–
24 3 CC3+ unused Zclk+
12 15 CC4+ unused Z3–
25 2 CC4– unused Z3+
13* 13* inner shield / ground* inner shield / ground* inner shield / ground*
26* 26* inner shield / ground* inner shield / ground* inner shield / ground*
* For PoCL, pins 1 and 26 change to +12V DC power, while pins 13 and 14 change to +12V DC power return.
CAUTION! Never plug a non-PoCL device (camera, cable, extender, etc.) into an EDT board that
has the PoCL jumpers in the “enabled” position. Doing so will cause a short – indicated by a red
LED (which may be obscured by your backpanel) on the back of the board, near the associated
connector – and may damage your equipment.