Edmunds Gages Trendsetter II, Руководство пользователя

Страница: 11 / 82

1-5
1.4 Quick Start Guide
The following steps must be taken to prepare the Trendsetter II

for operation.
1) Unpack and setup the unit.
•
Rotate the front foot 90
°
from its shipping position.
•
For air gaging applications, rotate the rear foot 180
°
from its shipping position and
install the filter regulator assembly. Connect 60 psi min supply air to the filter
regulator assembly
Note: See "Basic Operations, Unpacking & Setup " for additional information, page 3-1
2) Setup and install the signal conditioning module if it was not installed before
shipment and connect the gage tooling.
•
Check that the jumpers and switches on the LVDT or A/E signal conditioning board
to be used are properly setup for the application to be run.
•
Install the signal conditioning module into the lower bay and secure with the two
thumb screws on the front panel.
•
Plug in the LVDT(s) or airline from the gaging fixture to the signal conditioning
module.
Power to the column must be turned off prior to installing or removing a signal
conditioning module.
Note: See the " Advanced Operation , Module Setup" section for additional information,
page 4-1.
3) Program Trendsetter II

for the application.
•
Plug the power cord into the rear of the unit and to a 100 VAC to 240 VAC 50/60 Hz
power supply. Turn the unit on using the on/off switch on the rear of the unit.
•
Using the programming keys and the enter button program the scale, range, mode,
and limits for the application.
Note: See the "Basic Operation, Programming " for additional information, page 3-7
4) Set up magnification and zero for the gage input or inputs.
•
Using the masters for the gage tooling and the mag and zero adjustments on the signal
conditioning modules setup the LVDT(s) or air inputs.
Note: See "Basic Operation, Input Setup " for additional information, page 3-10
5) Select the proper gaging mode using the programming keys, see page 3-17. The
unit is ready for gaging.