The pumping height can be regulated by means of the float switch
(4) and its position in the float switch locking device (3).
Please observe the following information regarding the float switch
(4):
▶ Make sure that the float switch (4) always has enough clearance
and is not permanently activated. This could prevent the automatic
switch-off causing the device to run dry. This would damage the
pump.
▶ Make sure that the float switch (4) is able to move freely and does
not suffer from a limited mobility caused by obstacles.
▶ Observe a sufficient distance between float switch (4) and float
switch locking device (3), for this could prevent the automatic
switch-off causing the device to run dry.
▶ Make sure that the position of float switch (4) is adjusted in a way,
that it does not lie flat on the ground. This could prevent the auto-
matic switch-off causing the device to run dry.
If required, lock the float switch (4) in
the desired position by pushing the
cable into the float switch locking
device (3) at the side of the pump.(see
fig.8), when the float switch is at a
certain water level, it will automatica-
lly start or shut off. (see fig. 8)
If the opposite function of the cable
clip is inserted into the float switch
locking device (3) and the float switch
cable is pulled to the correct position,
the float switch will be always open
unless manually removed or shut off.
(see fig. 9)
fig. 8
fig. 9
Please observe the following information regarding the device
set-up and before switching the device on:
▶ The float switch (4) must be able to move freely. The shaft into
which the device is lowered must not restrict the mobility of the
float switch (4) in any way.
▶ Do not leave the device running unattended.
▶ Make sure that the device is firmly placed on the ground or safely
suspended.
POSITIONING THE DEVICE
POSITIONING THE DEVICE
▶ When using the device in bodies of water with natural, muddy
ground, set the device up at a slightly elevation position, e.g. on
bricks.
▶ Check whether the hose or pipe was attached properly.
▶ Make sure that the power cable (2) is not under tensile load and has
enough clearance.
▶ Make sure that the mains connection corresponds to the specifica-
tions provided in the technical data.
▶ Check the mains socket for its proper condition and sufficient
fusing.
▶ Make it impossible for moisture to reach mains plug or socket.
THERE IS A RISK OF ELECTRIC SHOCK!
Ref. 08792
Instruction manual
ES
PT
FR
EN
