250714103200
7
7
Adding Oil (4-Stroke and Diesel engines only)
WARNING!
Using the wrong oil
can damage your engine and
void warranty.
Acceptable Oil Grades:
10W30
/ 10W40 / 15W30 / 15W40.
WARNING!
Do not overfill or tilt
while filling.
With the engine perfectly level:
1.
Open the “front access panel”.
2. Remove the
“oil filler cap” on the side of the engine.
3. Fill with engine oil until oil starts to run back out of the filler hole.
4. Replace the filler cap.
5. Clean up and excess oil.
Adding Fuel
WARNING!
Only use fresh clean commercially available pump Diesel.
WARNING!
Do not use fuel substitutes such as ethanol, methanol or biofuel in your engine, using such fuel
will cause damage and void any applicable warranty.
ATTENION!
Before refuelling ensure the engine is switched off and has cooled
NOTE!
It is normal for smoke to be emitted from a new engine for the first 5
hours of use while running in.
1. Clean surface around fuel cap to prevent contamination.
2. Loosen fuel cap slowly. Rest the cap on a clean surface.
3. Carefully pour fuel into the tank. Avoid spillage.
4. Prior to replacing the fuel cap, clean and inspect the gasket.
5. Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage.
Starting the engine
ATTENTION!
Disconnect all appliances before starting engine.
1. Make sure any protective switches / circuit breakers are switched off.
2.
Turn the “Ignition Key” “ON”.
3. Start the engine:
If the battery has enough charge, use the
ignition key to start the engine by holding the key in the “Start”
position for a few seconds (New batteries can have no/little charge; jump start or change battery if
needed).
4. Turn on any protective switches / circuit breakers.
5. Connect your appliance(s).
6. Turn on your appliance(s).
IF ENGINE WILL NOT START:
1. Check Oil Level.
2. Charge battery or jump-start if needed.
3.
See section “Troubleshooting”.
