11
Installation
Mount control enclosure to the wall and use the wiring diagram
on the following page to wire the components. WARNING: Do
not wire the 120V power until all the wiring has been
completed. Plugging in the system is the last step in wiring.
Always disconnect the power source before adjusting or
rewiring the control panel.
Mount the photoeyes in the door jamb 6” to 8” from the floor.
The maximum distance between eyes must not exceed 20 feet.
Position the wall pushbutton in an accessible location. Carefully
pry the button’s switch cover off. Loosen the two exposed
screws, then carefully pry the button base from the frame.
IMPORTANT:
Garage doors can cause harm to people and / or things. Never
allow children to play with the garage door. Do not use the
garage door as a pedestrian exit.
